FRV FOOD 70 is an innovative patented machine which provides a new system for a complete cleaning and sanitising in food processing areas, such as: supermarkets, food factories, industrial kitchens.
Dense foam allows to optimize the chemical cleaning and sanitizing action.
By vacuuming the residual liquid from floor, the environments are left completely dry after cleaning operations.
The cleaning process is carried out through four stages:
- Spraying of dense foam on all the surfaces
- Foam chemical action
- Rinsing with clean water, at a controlled pressure
- Vacuuming of residual water and dirt from floor.
The FRV FOOD models, equipped with a specific gun, are
able to nebulize the sanitizing chemical in the form of a liquid solution in 100
micron particles. With the nebulization at 100 micron the particles
deposit evenly on the surfaces wetting them slightly and after a few
minutes the particles evaporate, leaving the surfaces dry. In this way the chemical
is able to act for the necessary time to carry out its sanitizing action. This
is the ideal solution to quickly sanitize all washable surfaces.
The FRV FOOD models are able to nebulize a sanitizing chemical through a specific hand gun for turbo-nebulization@50micron. This gun allows you to deliver
a mixture of air and very fine particles of pure sanitizing product with a diameter of only 50micron.
Their small size allows the particles to remain in suspension in the sanitizing air jet, which can reach points 4 meters away from the operator. By directing the jet appropriately, it can easily reach every point in the room and saturate small rooms quickly and evenly.
With turbo-nebulization@50micron, the particles wet surfaces very little, leaving them only slightly damp for a few minutes. In this way, the product is able to act for as long as it takes to perform its sanitizing action in all points.
Moreover, by adding a special Santoemma device, it is possible to deliver a sanitizing chemical
in the form of 7 micron dry fog. The dry fog is delivered for a time
sufficient to completely fill the rooms and then left to act for a few minutes
in order to exercise its sanitizing action. This type of dry fog allows you to
reach every point, without wetting the surfaces. The machine can be left
inside the room to be treated. Alternatively, you can leave the machine out of
the room, placing inside only the chemical tank.
FRV FOOD 70 is indicated for a complete cleaning and sanitizing of all the surfaces, including walls, refrigerator cells, work-tables, machinery and transport trolleys in food processing areas, such as:
-
Supermarkets, in food preparation areas (fish and meat processing) and storage areas (refrigerator cells).
-
Medium-sized factories producing and packaging food (meat, salami, fish, milk/cheese, vegetables), butcheries, dairy factories.
-
Big manufacturing plants, to clean machinery, tooling and transport trolleys
-
Caterings and industrial kitchens, to clean rooms and food preparation areas.
-
Cleanrooms in food packaging factories and pharmaceutical factories.
-
Better cleaning and sanitising result: dense foam does not immediately fall onto the floor, but stays on the surfaces where it has been sprayed for some minutes. The foam prolonged action assures to make the most of the cleaning effect of the product, ensuring both cleaning and sanitising effect.
-
Visual effect of foam: foam covers in white all the surfaces where it is sprayed such as walls, sinks, fixtures. The operator can therefore check that every corner has been covered, thus allowing a complete action in every point.
-
Complete sanitizing action: Laboratory tests certify that using the machine in combination with specific chemicals, it is possible to kill 99,9% of bacteria.
-
Rinsing at a controlled pressure avoids that any particle is jumping on other surfaces and prevents the creation of a haze of water vapours, which would keep in suspension the micro-organisms for several minutes. These micro-organisms would fall again on the surfaces after rinsing, affecting the efficacy of the bactericide action.
- Saving of time: while foam acts on the surfaces where it has already been sprayed, the operator is free to operate on other surfaces. Therefore, even a big room can be completely foamed in a short time and there is no idle time.
-
Detergent saving: the chemical is used without waste because it does not immediately fall onto the floor.
-
Reduced power consumption: the machine requires little electrical power and therefore it can be used in any place.
- Filling the fresh water tank is easy, connecting the machine directly to the water network. When completed, filling is stopped by a floater, located in the water tank
- It is possible to leave the machine connected to the water network, for foaming and rinsing with unlimited autonomy.
- The discharge of dirty water is carried out easily thanks to a sufficiently long hose.
- The control/regulation panel is handy and the controls are simple and intuitive.
- The tank containing pure detergent is placed in a special compartment and the detergent is automatically sucked by the machine at the correct concentration.
- All accessories for cleaning and finishing are placed on the machine, so they can be easily used and carried.
|
Approximate performance:
|
Surface of 120m² |
1) Complete cleaning and sanitizing:
Time:
Chemical consumption:
Water consumption:
Defoamer consumption:
|
25 min
1200 gr (10gr/m²)
70 liters
max 70 gr
|
|
2) Quick sanitization:
|
|
2a) with Nebulization@100micron
Time:
Chemical consumption:
Water consumption:
|
2 min
200 gr (2gr/m²)
3500 gr (30gr/m²)
|
2b) with Turbo-Nebulization@50micron
Time:
Chemical consumption:
Water consumption:
|
3 min
240 gr (2gr/m²)
-
|
2c) with KIT for Dry Fog@7micron
Time:
Chemical consumption:
Water consumption:
|
30 min
1200 gr (4gr/m³)
-
|
|
Recovery tank capacity:
|
70 litres |
Clean water tank capacity:
|
70 litres |
|
Chemical dilution:
|
Pre-set around 4% |
|
Continuous filling system:
|
YES |
|
Vacuum motor:
Power:
Max waterlift:
Max air-flow:
|
2 x 2 stages
2 x 1000 W
2200 mm H2O
100 l/sec. |
|
Pump with by-pass:
Power:
Max pressure:
Rinse pressure:
Rinse water-flow:
|
Piston type, adj. pressure
370 W
30 bar
16 bar
5 l/min
|
|
Compressor:
|
350W |
|
Cable length:
|
10 m |
|
Weight (machine body):
|
105 kg |
|
Weight (packaged machine):
|
131 Kg |
|
Dimensions:
|
50 x 89 x 138 cm |
|
Package dimensions:
|
65 x 102 x 155 cm |
|
Units/pallet:
|
1 pz/pallet
(65 x 102 x 130h) |
|
Spray hose / vacuum hose length:
|
15/7,5 m |
|
Standard color:
|
Blue |
|
Tank construction:
|
High density polyethylene |
|
Noise pressure level - ISO3744 (1m):
|
75 dB(A) |
Power supply:
|
cable - 220-240V 50-60Hz
(other voltages on request)
|
| International Patents: |
EP 22772603.1 + US 18/683358 + CN 202280057576.4
|
Included accessories
The machine is supplied as standard with the following accessories:
Recommended accessories and devices
In order to optimize the results that can be obtained by this model, we suggest the adding the following accessories and special devices:
Other compatible accessories and devices
Below are listed all the accessories and devices that can be used with this machine
