CAR Wash professional interior cleaning and sanitizing program
For the interiors of cars and other vehicles, it is important to perform a regular cleaning, in order to remove the visible dirt and also to perform a periodic sanitization of all the surfaces, to remove the non-visible elements such as germs and bacteria as well.
For cleaning and sanitizing upholstery and textiles surfaces, Santoemma produces a complete range of machines, innovative and with high performances, which use a cleaning and sanitizing solution or a dense foam. These machines are able to perfectly remove all the dirt, leaving the surfaces dry quickly after cleaning.
Santoemma CAR Wash interior cleaning and sanitizing program includes several machines and chemicals suitable for the professional cleaning of seats and inside of cars. Different cleaning systems are available in order to comply with the specific application need and the operators' cleaning preferences.
A solution of water and chemical is sprayed into the fibers of the textile and immediately sucked. The solution and the dirt removed are recovered in the machine body.
In seats and textiles cleaning, the cleaning result can be improved by using a hot solution, instead of room temperature solution.
Specific tests show that cleaning carpet with just 10°C more can give the same result as cleaning twice.
Santoemma machines can be equipped with an instant heater that allows you to immediately heat the water used for cleaning. In this way a much better result is obtained in cleaning seats and textiles, even very dirty.
The maximum temperature is limited to 65-70°C in order not to damage the textiles. These temperatures allow you to effectively clean and sanitize seats and fabrics.
The use of hot water also reduces the dryingtime and is appreciated for working in winter and in cold areas.
A special dense foam is sprayed on the textiles and is sucked after some seconds.
Dense foam does not penetrate deep inside the textiles, therefore allowing a short drying time: seats can be dry in 20 minutes!
In order to obtain the special dense foam, the chemical solution is mixed with compressed air, obtained by a dedicated air compressor. The quality of foam is therefore much better than the "liquid foam" of machines without compressor. Thanks to its optimal density, dense foam penetrates for few millimeters in the superficial layer where the dirt lies. It does not remain only on the surface, as it happens with "dry foam". Therefore, dense foam allows an excellent cleaning result, even without any mechanical brushing action. The manual tool is very light and compact, for cleaning many seats quickly and without effort. Its shape also allows you to reach any corner.
Turbo-nebulization@50micron
In addition, Santoemma dense foam extraction models can be equipped with the special gun for turbo-nebulization@50micron to
to completely sanitize the passenger
compartment after interior cleaning
. With this gun it is possible to deliver
a mixture of air and very fine particles of pure sanitizing product with a diameter of only 50micron.
Their small size allows the particles to remain in suspension in the sanitizing air jet, which can reach points 4 meters away from the operator. By directing the jet appropriately, it can easily reach every point in the room and saturate small rooms quickly and evenly.
With turbo-nebulization@50micron, the particles wet surfaces very little, leaving them only slightly damp for a few minutes. The
sanitizing particles are nebulized into the passenger compartment,
saturating it, and reaching even the most difficult to reach places,
including air conditioning ducts.
The car is ready to use immediately after the sanitizing treatment.
The innovative accessory for the turbo-nebulization@50micron allows you to use a single Santoemma machine for:
cleaning and sanitizing car and vehicle upholstery with the dense foam extraction system
sanitizing completely the car interiors, by nebulizing a sanitizing chemical.
The two operations can be performed with the most
appropriate frequency, according to the specific needs.
Dry fog@7micron
Santoemma dense foam extractors can be equipped
with an optional device for generating dry fog@7micron. This
system allows you to carry out the complete sanitization of vehicle interiors without
wetting the surfaces. Therefore it is ideal for ambulances and
emergency vehicles.
With the Kit for dry fog@7micron it is possible
to quickly sanitize interiors of large vehicles, such as trucks,
coaches, trams, buses, shuttles, subways cars.
The dry fog is dispensed long enough to completely
fill the interiors and then left to act for a few minutes after
saturation in order to perform its sanitizing action.
The machine is left out of the vehicle. Only the
chemical tank with the dry fog dispenser are placed inside and they are
connected to the machine through a 10-meter hose. The whole interior can be
saturated in a few minutes with no need for the operator to stay inside.
Microsoft Office Translator
This system, patented by Santoemma, uses hot dense foamwhich ensures excellent cleaning results even in case of extremely dirty upholstery and an even shorter drying time.
This system is particularly appreciated to work in winter and in cold areas.
The hot foam is immediately available as the machine is switched on.
Turbo-nebulization@50micron
In addition, Santoemma dense foam extraction models can be equipped with the special gun for turbo-nebulization@50micron to
to completely sanitize the passenger
compartment after interior cleaning
. With this gun it is possible to deliver
a mixture of air and very fine particles of pure sanitizing product with a diameter of only 50micron.
Their small size allows the particles to remain in suspension in the sanitizing air jet, which can reach points 4 meters away from the operator. By directing the jet appropriately, it can easily reach every point in the room and saturate small rooms quickly and evenly.
With turbo-nebulization@50micron, the particles wet surfaces very little, leaving them only slightly damp for a few minutes. The
sanitizing particles are nebulized into the passenger compartment,
saturating it, and reaching even the most difficult to reach places,
including air conditioning ducts.
The car is ready to use immediately after the sanitizing treatment.
The innovative accessory for the turbo-nebulization@50micron allows you to use a single Santoemma machine for:
cleaning and sanitizing car and vehicle upholstery with the dense foam extraction system
sanitizing completely the car interiors, by nebulizing a sanitizing chemical.
The two operations can be performed with the most
appropriate frequency, according to the specific needs.
Dry fog@7micron
Santoemma dense foam extractors can be equipped
with an optional device for generating dry fog@7micron. This
system allows you to carry out the complete sanitization of vehicle interiors without
wetting the surfaces. Therefore it is ideal for ambulances and
emergency vehicles.
With the Kit for dry fog@7micron it is possible
to quickly sanitize interiors of large vehicles, such as trucks,
coaches, trams, buses, shuttles, subways cars.
The dry fog is dispensed long enough to completely
fill the interiors and then left to act for a few minutes after
saturation in order to perform its sanitizing action.
The machine is left out of the vehicle. Only the
chemical tank with the dry fog dispenser are placed inside and they are
connected to the machine through a 10-meter hose. The whole interior can be
saturated in a few minutes with no need for the operator to stay inside.
When cleaning textiles, the drying time after vacuuming strongly depends on the vacuum strength.
A specially designed High Waterlift vacuum system is equipped on Santoemma machines, allowing to get up to 50% higher waterlift than standard extractors. This results in an extremely shorter drying time than with normal machines. Not only the drying time is reduced, but also a better cleaning result is obtained, since the extra solution extracted from fibers contains extra dirt removed from the surface. The same residual dirty solution, if left evaporating on textiles as it normally happens, would leave the surface not so clean as with high waterlift machines.
Injection-extraction
HOT Injection-extraction
Dense Foam extraction
HOT Foam exrtraction
SW15
X
SW30
X
SW50
X
SW70
X
SW30-BATTERY
X
SW15-HOT
X
X
SW30 + HT1800
X
X
SW50 + HT1800
X
X
SW70 + HT1800
X
X
SW15-FOAM
X
X
SW15-FOAM-LIGHT
X
X
SW15-HOT-FOAM
X
X
X
X
SW15-HOT-FOAM-LIGHT
X
X
X
X
T-CLEAN
X
X
T-FOAM
X
X
The machines of Santoemma CAR Wash program can be used in different areas.
By clicking on the area, it is possible to view the most suitable machines.